Print Experiments

This article was published Aug 29, 2018.

Here is some experiments from last night. Second two last images shows what happens when the supports are to weak and loose grip with the board.. I am using the gray filament for all these tests cause I found out that both black and gray gives much more stringing and much less grip for paint later on. When I got it right I print another in white filament which gives a much better surface and just fantastic grip for paint afterwards. I googled around a lot, but no one seems to (what I found so far..) complain about the difference in filament colour. Clearly there is "some" difference ....

For coming prints I will add a little "foot" to each support so it doesn´t loose it. It is a great learning experience!

211955
211955
071009
071009
071257
071257