FR - Monitor Sölve, Hull V3 first

This article was published Feb 26, 2019.

112049
112049

Second hull version failed to, twice ... But, I am not giving up, I want my boat!

This time I did split the hull in eight pieces so I could lay them down (my printer-bed is 15*25 cm and 17 high, still rather much for a home printer). Instead of avoiding infill and supports I try to take advantage of it. All pieces are solid this time, no grid inunder. Instead I will print with 18% infill (default in Cura) instead of making the grid myself. Also lowered it a bit so it lays lower in the water. Joints between pieces are this time at 45 degree angle, hopefully making the joints easier to hide.

112203 -- third piece of cheese, first and second in the background
112203  -- third piece of cheese, first and second in the background
233417 -- during waits I added some paints to details already made
233417  -- during waits I added some paints to details already made
233433
233433
103134 -- started on a little deptford 1 plank wagon during waits
103134  -- started on a little deptford 1 plank wagon during waits