Yellow Ridge - Jenbach 20

This article was published Dec 07, 2023.

This is a loco I did draw many years ago for ShapeWays. This is a new version "in around" 1:20-ish scale. The intention was to increase it to G scale at 1:22.5 ratio to fit on top of my Regner motor chassis, but it got a tiny bit to small for that, so I increased it until it did. This will be printed on my sons new thread printer (same as Adam Savage did demonstrate on his channel a while ago, Bambu Lab X1-Carbon Combo 3D Printer).

Regner trains is 1:22.5 scale on the odd gauge 30mm.

/Henrik