Tools - Fumes Cabinet, part 3

This article was published Dec 23, 2019.

Continued with the cabinet this evening. The plywood I thought I had was to narrow ... I need 60 cm, but all in store was 50 cm, left overs from last layouts I built. Will have to wait until after Xmas when the lumber yard opens again ...:sad:

Soo, had to focus on the fan exhaust pipe instead and the connector out the window. Will start print it tomorrow. It will take plenty hours, so good use of time during festivity up stairs ..:smile:

211601
211601
215712 -- testing inside height of the cabinet w printer in place
215712 -- testing inside height of the cabinet w printer in place
01 -- -- top piece of the connector fits exactly in my dremel, lucky I have such big printbed --
01 -- -- top piece of the connector fits exactly in my dremel, lucky I have such big printbed --