Tools - Fumes Cabinet, part 7 & DONE!

This article was published Dec 31, 2019.

New Years Eve or not, I just couldn´t give up this close. At 17:17 GMT+1 I did start up the AnyCubic Photon printer inside a fully functional Fumes Cabinet for the first time !! Yeeahh !!:grin:

Now I can print also resin in my cave while working, except a little noise from the kitchen fan..:tongue:

First item (or second in total) is the Carolean Howitzer. If it is a success or not doesn´t matter, my "3D studio" is now fully functional again !!

Happy New Year everyone!

170113 -- did not know how to cut out the hole, but a jigsaw worked just fine
170113 -- did not know how to cut out the hole, but a jigsaw worked just fine
092247
092247
092303 -- the hose installed and easy to remove with just a bit tape around above square which the hose goes through
092303 -- the hose installed and easy to remove with just a bit tape around above square which the hose goes through
172201 -- from the outside
172201 -- from the outside
172414 -- Time was 17.17 GMT+1 when I pressed the button!
172414 -- Time was 17.17 GMT+1 when I pressed the button!