Mil - Carolean Howitzer 2
This article was published Mar 14, 2020.
Today the second print of the howitzer was finished. With all pieces printed as one made a 100% flawless print! One second less exposure than recommended, well shaken resin and clean FEP (the clear film at the bottom of the tray) gives this amazing result! Also re-printed the gears for my friend I showed you before. Half is standing straight up and half is leaning just a bit. Surprisingly both got equally good, only thing which got different is depending on how much supports I added. Again those with less supports got the best - as long as they have at least 3 or 4 points to hold them in place. With the cogs sticking out only a bit over one millimeter, they did not need any supports at all.. only at the bottom.