Mil -Washable Photopolymer resin
This article was published Mar 24, 2020.
Did print the last anycubic green last weekend (the green hay wagon below). After that I did a test print with the Elegoo Washable photopolymer resin which went well. The famous sheet recommended 8 sec exposure, but my best result was with 7 sec. After the test I continued printing the hay wagon, but three failed prints so far cause of bad adhesion, the model gets loose from it´s supports and fall down in the tray before finished. This resin is much thinner in the consistency then the previous I used, so seems understandable. Right now I trying with a bit thicker bottom layer and even more supports in place. If that doesn´t work either, I will redo all supports with a bit thicker ones. So far I only used the lightest type since that makes the least impact and easier to remove afterwards.